CAT&FISH Extruder Disk Set

Would you like to create a CAT&FISH soap cane for your soap? Well, now you can!

The sizes in this disk sets are as follows:

18mm, 25mm & 54mm (You need all three extruder disk tools to create this design)


The filament used for these disks is made at Prusa, shipped to me from Prague. All batches are quality tested and you can go on their website and enter in the batch number to see testing and results with your specific batch. This filament is very high quality and not cheap filament purchased off of Amazon.

These extruder disks are 3D printed using PLA. This material is a thermoplastic aliphatic polyester and it is the primary natural raw material used in 3D printing. PLA is a fully biodegradable thermoplastic polymer consisting of renewable raw materials. The extruder sets are made 2mm thick. The small extruder disks are 18mm diameter and the large are 25mm diameter and will fit most clay extruder tools. If you need a custom size or have any questions, please feel free to message me. These are *MADE TO ORDER, so please allow a few days for printing.

Clean with warm water after each use. Do not put in dishwasher, as the heat may damage the disk.

*WE ARE NOT RESPONSIBLE FOR OUTCOME OF DESIGN, as everyone has different quality/consistency of their soap clay. All Extruder disk sets have been tested many times, by many different testers and have been found to work reliably.


*Please refer to photos or message me if you have any questions about the size of disk sets before you purchase.

**AS ALWAYS, WE REFUND ANY SHIPPING OVERAGES**