Panda and heart EXTRUDER DISK SET

This is an extruder disk set to make a panda and heart. Disk sizes are 54mm, 25mm and 18mm. *YOU NEED ALL THREE SIZES to complete this panda. If you need advice on which extruders to buy, please message me and I'll get back to you asap.

This listing is for the extruder disks only and does NOT include the soap.

**Please feel free to watch our YouTube video if you need help putting all the pieces together.

These extruder disks are 3D printed using PLA. This material is a thermoplastic aliphatic polyester and it is the primary natural raw material used in 3D printing. PLA is a fully biodegradable thermoplastic polymer consisting of renewable raw materials. The extruder sets are made 2mm thick. The small extruder disks are 18mm diameter and the large are 24mm diameter and will fit most clay extruder tools. If you need a custom size or have any questions, please feel free to message me. These are *MADE TO ORDER, so please allow a few days for printing.

Clean with warm water after each use. Do not put in dishwasher, as the heat may damage the disk.

** This set contains a total of 6 disks.
The face is 1 disk (54mm)
The ears is 1 disk (54mm)
The eyes is 1 disk (54mm)
The heart has 2 disks (25mm)
The Panda nose is 1 disk (18mm)

*WE ARE NOT RESPONSIBLE FOR OUTCOME OF DESIGN, as everyone has different quality/consistency of their soap clay. All Extruder disk sets have been tested many times, by many different testers and have been found to work reliably.


**AS ALWAYS, WE REFUND ANY SHIPPING OVERAGES**